Flotec pressure switch manual






















Switch Pressure Switch Flow to Pressure Tank and Household Water System Foot Valve Ejector (Jet kit contains nozzle and venturi) Suction Pipe Drive Point Well Seal Check Valve Cased Well Driven Point Well Drive Coupling Volt Power Supply Terminals Volt 1 15 INSTALL THE PUMP 1. Locate the pump near the water source. 2.  · The starting and stopping of a well water pump is typically controlled by a pressure switch similar to the one shown below. The switch is preset with both the cut-on and cut-off pressure. The cut-on pressure is the low pressure that starts the pump and the cut-off pressure is the high pressure that turns off the pump. Buy the FloTec FP In-stock at Power Equipment Direct. Also, read the latest reviews for the Flotec FP - 12 GPM 1 HP Cast Iron Vertical Deep Well .


Industry or Flotec news of notable importance to the Emergency Medical, Health Care, and Hospital community. July 9, Power Point. EMS Presentation for Fire Chief Summit. Octo. Products. Listing of products with links to brochures. December 6, Service Manuals. pressure switch as shown. Tank and pressure switch cannot be more than 10’ (3M) apart. NOTICE Tank capacity is different than drawdown. Tank capacity is the actual physical volume of the sheet metal that makes up the tank. Operating Cycle Step 1. Tank nearly empty – air expands filling area above bladder (Figure 2A). Step 2. pressure in centrifugal pumps depends on the number of impellers in the pump housing, the clearance of the impellers to the housing and the power of the motor to drive the impeller/s volume flow is also important as a pump without a high output will not produce pressure check the jet size at the foot valve that is used to help lift water to the pump It is a jet pump and will have a smaller.


The Flotec AUTOJET pump is suitable for pumping clean water in an urban additionally, refer to the pressure controller installation and operating. For parts or assistance, call Flotec Customer Service at (The first number on the pressure switch is the pump on setting; the second number. г. Facing well pump pressure switch problems can be daunting. There are so many different places where the pressure could possibly be lost.

0コメント

  • 1000 / 1000